Schematic – Parts List
Proposed Theoretical In-Vivo Blood Pathogen Neutralizing Device
COMPONENT DESCRIPTIONS

Note: These data are for theoretical, informational and instructional purposes only and are not to be construed as medicaladvice. Consult with your licensed medical practitioner. Hundreds have been built successfully if duplicated exactly as shown.

LM358 CMOS Operational Amplifier (OP-AMP) chip (generic) U1
2 x 100k Ohm ¼ watt 5% resistor R1, R2
150k Ohm ¼ watt 5% resistor R3
2.4 (or 2.2) Meg Ohm ¼ watt 5% resistor R4
820 Ohm ¼ watt 5% resistor R5
150 Ohm ¼ watt 5% resistor R6
100k Ohm linear taper potentiometer with SPST switch SW1
0.1uF 50 V (or higher) ceramic capacitor C1
22uF 35 V (or higher) electrolytic capacitor C2
2 x 18 Volt Zener diodes, ½ Watt (NTE5027A) D1, D2
Bulb, 6 - 12V @ 55mA or 6.3V @ 0.075A, Type ML612 or 7377 BULB1
Bicolor LED Red/Green LED1
Jack for electrode leads (3.5mm or 1/8” mono-phone jack) J1
Jack for silver wire leads (2.5mm or 3/32” mono-phone jack) J2
3 x Alkaline 9 Volt batteries, type 1604 etc. BAT1-3
3 x 9 Volt battery snaps (clip-on connectors) Misc. wire, solder, etc.
If used: Box; Bread Board; 8-Pin IC Socket
Lead wire with 3.5 mm plug, 6 ft., Mouser or Calrad Electronics
Electrodes, stretch elastic, Velcro, cotton flannel, alligator clips, etc.

Ensure the IC chip U1 (LM358) is wired correctly.
The location of Pin #1 is shown: