DETAILED DESCRIPTION
You have a row of GPIO pins on your uC. You can put a servo control signal out on each one. But then you have to connect that to a servo and provide motor power.
Before, the options where, take up 3 rows on the bread board for each servo and try to find extra long header pins, or undo the header on the servo connector and stick wires in the end (which move around, short, or fall out), or buy a big expensive "shield" or other full sized adapter.
This little board takes up no extra space, ties into the power rail, provides a little terminal block to screw in wires from a battery pack, and most importantly, provides a mechanically stable place to plug in servos.
Authors
- /
- Active Participants
Components & Releases
Fabricate
Delete release
Are you sure you want to delete this Release?
This action cannot be undone.
Unable to download from CircuitMaker
You cannot download files inside CircuitMaker.
Please, open this page in browser and download file from there.
To copy hyperlink, press Ctrl+C with selected text below:
Comments ()